Page 22 of 22

Re: '64 Aussie Morris 850

Posted: Mon Feb 03, 2025 4:13 pm
by snoopy64
;) Just the job

Re: '64 Aussie Morris 850

Posted: Tue Feb 04, 2025 8:11 am
by roger mcnab
hi tim
the seats look good i fitted a pair of laser seats that i had sitting around looking for some where to go they fitted in very well just some brackets for the rear mounts and the tracks slide the seats forward and then lean forward as well access is very good and the seats are comfortable and are easy to adjust with the slides right height and allgave the tombstone ones to a friend for his mini and getting a lot of welding done in exchange
cheers roger and the forum is up cheers again :D :D :D :D :D

Re: '64 Aussie Morris 850

Posted: Tue Feb 04, 2025 1:47 pm
by snoopy64
timmy201 wrote: Sun Feb 02, 2025 8:24 pm I’ve just remembered all the old photos are missing from earlier in the thread (thanks Flickr) so here’s some close ups of the lenses
How have you got them mounted?

Re: '64 Aussie Morris 850

Posted: Tue Feb 04, 2025 8:47 pm
by timmy201
snoopy64 wrote: Tue Feb 04, 2025 1:47 pm
timmy201 wrote: Sun Feb 02, 2025 8:24 pm I’ve just remembered all the old photos are missing from earlier in the thread (thanks Flickr) so here’s some close ups of the lenses
How have you got them mounted?
The studs on the back of the lamp housings poke through the grille, then the flat metal bar is put on, then the nuts. The wires poke though a slat as well. It also came with a little rubber wedge to correct the angle for different applications

Much more recently I found a NOS set for sale and saved the instructions from the listing