Page 3 of 3
Re: Remote Diff housings
Posted: Sun Jun 28, 2020 8:29 pm
by Spider
251 ENG wrote: ↑Sun Jun 28, 2020 3:13 pm
Spider , where to you get the diff centre size of 4.000" - 4.003' from ?
I don't recall off hand what the center size of the diff is and I'm sure I haven't mentioned that in this thread. I have mentioned the center to center distance though, is that what you are referring to ?
Re: Remote Diff housings
Posted: Sun Jun 28, 2020 9:02 pm
by 251 ENG
Yes that's it
Re: Remote Diff housings
Posted: Sun Jun 28, 2020 9:06 pm
by Spider
I have a factory table of the gears from the early boxes, that has the gear specs in it, including the PC Diameters of them,
Re: Remote Diff housings
Posted: Sun Jun 28, 2020 9:29 pm
by 251 ENG
That's spot on , thanks
Re: Remote Diff housings
Posted: Mon Jun 29, 2020 1:30 pm
by 251 ENG
Is they a factory size and tolerance for diff bearing bore ?
Re: Remote Diff housings
Posted: Mon Jun 29, 2020 2:02 pm
by agricola
You will be dictated by the bearing so bearing suppliers should give you that