flasher!!!!

[Dean]

no its not what your thinking .

i am doing my wiring ( fully dressed) and i am try to work out what flasher unit i need.
my car is a 62 car, with a new loom from autosparks, i had it adaptered to also have hazards lights, with the switch hidden under the dash

under the bonnet where the flasher unit is, i have 5 cables instead of 3, which i know that the extra 2 are for the hazards,

do i use the mk1 flasher, and have another flasher for the 2 extra cables for the hazards

or do i have to find a flasher which takes 5 cables.

in any case does any one know which unit or units i need

thanks dean

[Charlynsane]

On a k1 you need 3 cable

Dark green

Light green/brown,

Light green/purple,

But Be careful, take a good flasher unit, at holden.co.uk, don't use a shity repro from Lucas sold at MS etc... it never works or a few months..

You shouldn't have extra cables..mayby for side repeater??

[Dean]

thanks for your reply.

i know mk1's only have 3 cables for the indicators flasher, but i have had hazard warning light wiring added in, its not something that was ever fitted to mk1 ones, but a good idea when i had my loom made, like i said the switch will be tucked under the dash. not to be seen but there when you need it.

at the point where the flasher is there are 5 cables, and these 5 cables are the same ones at the switch end inside the car, 1 links back to the fuse box

the 2 extra cables are not for the brake light switch as they are already plugged in

by the sounds of it i need the standard flasher unit for the indicators and one for the 2 spare cables to run the hazards.

is that right????

[Charlynsane]

Do you gave some pictures?

I can make so detailled pictures of my mk1 loom if you need..

[Dean]

ok i am popping over the garage later, am get a few photos

thanks

[Dean]

as you can see 5 cables,

[rich@minispares.com]

don't the three normal ones go onto the mk1 flasher, then the two lighter coloured ones go onto a separate flasher to drive the hazards?

[Dean]

thats what i kind of come round to thinking, as after searching for flashers, there are separate units for hazards.

so that kind of answers what i needed

1, no there is not 1 flasher unit with 5 terminals

2, i need a mk1 flasher for 3 cables
and a hazard flasher for the other 2.