Project Binky

[Pete]

Not something for the purist but an entertaining set of Youtube clips :

https://www.youtube.com/watch?v=7hCPODj ... U5tIiEZHBg

[swifty]

I've been watching this also Pete . Some vey good work gone into it though .... Ken

[Ollie78]

I've really been enjoying these as well, the end result probably won't interest me much but there's some great metal work going on.

[36inter]

That is superb fabricating, just wish I had half that ability, episode 4 next.

Pete

[iain1967s]

Well here we are, nearly eight years later…

Episode 1 posted Aug 17, 2013
Episode 35 posted Aug 7, 2021

Have to say, this has been a fantastic build to watch the progress, even if frustratingly slow at times. But it looks like they are getting ready to finally install the engine.

[jayare]

And no sooner than Episode 35 is out, episode 36 has followed!

https://www.youtube.com/watch?v=oFuu5jtbGiw

JR

[InnoCooperExport]

It's been a few years but Nik and Richard have announced there will be a new feature length episode of Project Binky this Saturday! Rejoice.

[Exminiman]

As we all know motorsport is all about “Brackets”

[roger mcnab]

hi
project binky is 1 of my favourite videos they are amazing the way the problems are solved i wonder what happened to the truck they were working on
it would be good to see binky running
cheers roger mcnab

[Exminiman]

Watched it almost open mouthed, unbelievable attention to detail and 3D printing solder WTF

https://youtu.be/Fy2_CUBz40A?si=jj3wQG2GePGxhkwe

[irlmin]

That is some incredible work . I can't imagine the time involved . G