looking for an FE# plate
-
AustinSuperSeven
- 850 Super
- Posts: 246
- Joined: Thu Jun 24, 2010 9:45 pm
- Location: Dorset
- Contact:
-
mk1
- Site Admin
- Posts: 19842
- Joined: Thu Jun 24, 2010 11:30 am
- Location: Away with the Faries
- Has thanked: 2 times
- Been thanked: 4 times
Re: looking for an FE# plate
NMP on front slam plate? (NMP in a diamond shaped emblem) = Nuffield Metal Pressings, (The plant that stamped the panels out, part of BMC but seperate from Austin, Morris etc)
Small plate on bulkhead stamped with numbers? = Body number tag. (Somtimes you have a body number as well as a VIN number quoted on Heritage certificates etc. This is that one).
Plates similar to FE plate on both front floorpans? = Floor Number. Identifies that body section in the factory, just like an FE number only for a different sub assembly.
And a small bolt with a welded flat top going through front floor pans (both sides)? = This is a fixture to which the car was attached in the factory. There are also sometimes 4 similar ones one in each corner.
Hope that the above makes sense.
Small plate on bulkhead stamped with numbers? = Body number tag. (Somtimes you have a body number as well as a VIN number quoted on Heritage certificates etc. This is that one).
Plates similar to FE plate on both front floorpans? = Floor Number. Identifies that body section in the factory, just like an FE number only for a different sub assembly.
And a small bolt with a welded flat top going through front floor pans (both sides)? = This is a fixture to which the car was attached in the factory. There are also sometimes 4 similar ones one in each corner.
Hope that the above makes sense.
-
AustinSuperSeven
- 850 Super
- Posts: 246
- Joined: Thu Jun 24, 2010 9:45 pm
- Location: Dorset
- Contact:
George