Pop quizz

[JC T ONE]

Hi all,


These are drawings, of the new bitz I had made for the car.

Here are 2 pictures =


and




Jens Christian

[gr4h4m]

Rocker gasket?

[JC T ONE]

Rocker gasket?

Yes its a alloy sandwich plate, that fits inside the lip, on the JanSpeed rocker cover.

It will have 4 holes drilled at the front, and pipes fitted.

Didnt want to drill & solder on the original rocker cover.



Jens Christian

[JC T ONE]

This is what the drawing ended up looking like (the small round piece, that holds the 3 pipes) =





So any guesses to where this goes ?

Jens Christian

[mk1coopers]

I can...........but only because you told me

[Nevsmini]

JC ill stick it where the sun don't shine if you don't tell us! is it a new electric prod for the misses, if so ill buy one off you!

[InimiaD]

^

Is it a "geigle pin" Jens.? I've always wondered what they looked like.

[JC T ONE]

I can...........but only because you told me

Ha ha, yes you know how the system is designed

This is actually a little bit like connecting a dish washer

JC ill stick it where the sun don't shine if you don't tell us!
is it a new electric prod for the misses, if so ill buy one off you!

^

Is it a "geigle pin" Jens.? I've always wondered what they looked like.

Hi guys

Well better tell what it is, as I dont want it "probing" my rear side




This is my new oil dip stick .

2 short pipes for the returning oil from the pump, and 1 long.
The long pipe is for the SMITHS oil check that has been "nesting" in a corner of the dash for 28 years.
It was disconnected, when JanSpeed built the car, as the SMITHS dip stick pipe for the gauge, dont fit into an A plus block,
= it was made for old 60ies engine types.


The pump will be controlled by a micro swith, on the throttle linkage,
so it only runs, when the car is idling (most vacumm = drowning the valves) .


Did a test run this eveing, so far so good = it keeps the oil level well below the original return channels, in the head.

Jens Christian

[SteveG]

I was going to say oil dip stick, but only as a joke!

Clever Stuff Jens.

[JC T ONE]

I was going to say oil dip stick, but only as a joke!

Well you were right Steve

Here is a video, to show how its fitted (tempoary setup) Later on will I make a tube,
that connects the 4 pipes, right where they come out, of the sandwich plate, and then make one center outlet, to the pump.

http://youtu.be/hsyx3czAkPo

Clever Stuff Jens.

Thanks for the kind words Steve, one can only try.



Jens Christian