Hi,
What way does the speedo drive i.e. cable end, rotate? Think speedo needs a hand to get over 78000. Probably wear in female bit on speedo due to loose cable!!
Thanks
Speedo cable rotation
-
- 998 Cooper
- Posts: 279
- Joined: Sat Nov 16, 2013 8:14 pm
- Location: Alyth,Perthshire,Scotland
-
- 1275 Cooper S
- Posts: 1264
- Joined: Thu Jun 24, 2010 11:55 pm
- Location: Tasmania, Australia
- Has thanked: 3 times
- Been thanked: 6 times
Re: Speedo cable rotation
It rotates in the same direction that the needle rotates.
Tim
Tim
1951 Morris Commercial J Type Van
1955 BSA C11G
1961 Morris Mini Traveller
1969 Triumph TR6R
1977 Leyland Moke Californian
1955 BSA C11G
1961 Morris Mini Traveller
1969 Triumph TR6R
1977 Leyland Moke Californian
-
- 998 Cooper
- Posts: 362
- Joined: Fri Aug 08, 2014 11:06 pm
- Location: New Zealand
- Been thanked: 2 times
Re: Speedo cable rotation
You're asking about the odometer, not the speedo right?
If the speedo still reads but the odometer is stuck then the problem is with the odometer barrel. They get clagged up with dirt and dust then jam up. I send the unit out to a local company who clean, test and refit the assembly.
Tried doing one myself once, doable but very fiddly. I much prefer paying an expert to do this job.
If the speedo still reads but the odometer is stuck then the problem is with the odometer barrel. They get clagged up with dirt and dust then jam up. I send the unit out to a local company who clean, test and refit the assembly.
Tried doing one myself once, doable but very fiddly. I much prefer paying an expert to do this job.
-
- 998 Cooper
- Posts: 279
- Joined: Sat Nov 16, 2013 8:14 pm
- Location: Alyth,Perthshire,Scotland
- Peter Laidler
- 1275 Cooper S
- Posts: 6143
- Joined: Sat Jul 15, 2017 5:35 pm
- Location: Abingdon Oxfordshire
- Has thanked: 29 times
- Been thanked: 30 times
Re: Speedo cable rotation
The odometer part is all a mechanical gear train. The most common fault is the tiny little claw on the eccentric operating lever has worn away and won't click - or rotate the initial rotor. That, followed by clag in that part of the mechanism as Kiwi Minibits says
Not the sort of thing that you're likely to have in your box of spare parts.
Not the sort of thing that you're likely to have in your box of spare parts.