So after a pretty stressful Friday afternoon ( the m6 traffic was a nightmare) we now have it all tucked up in its bespoke trailer.
![Smile :)](./images/smilies/icon_e_smile.gif)
Theres a vid coming out on Youtube in a couple of weeks.
Snapshot(12).jpg
But in short the trailer is no1 priority.
We have decided to lower it so it fits under our 4 post ramp (its 'just') too high, we'll fit the required lighting, reflectors etc that it needs, and replace the jockey wheel with one that has a locking pin!
The biggest decision we have taken is to widen the trailer as well, well not the trailer, more the covering and support framework, by moving the frame from inside the trailer runways to the outside we'll gain around 60mm?? in width. Its bastard tight at the moment, an absolute ballache to get in and out as witnessed by the marks it already has on the rear arches. The trailer rear ramps need extenders anyway as the car doesnt clear the rear door/ramp as it is now, and thats with the splitter removed.
I'd like to see us being able to load it in one / two pieces, rather than 3 at the moment (front end, splitter, car).
The entire things getting an overhaul as there isnt even any way to tie down the car at the moment, it was just wedged by some bits of wood and some cushions.
311435834_10229325209625747_6429489432028514402_n.jpg
You do not have the required permissions to view the files attached to this post.