What's the standard size for the primary gear backing ring and where is that measurement taken from? The whole ring, or the depth less the c-Clip?
Trying to take up around twelve thou of slack and I know that Mini Spares do an oversized by 2 thou ring.
Primary Gear backing ring - standard size?
-
GraemeC
- 1275 Cooper S
- Posts: 2288
- Joined: Thu Jun 24, 2010 1:05 pm
- Location: Hiding From The Dog... NW Eng
- Has thanked: 2 times
- Been thanked: 7 times
Re: Primary Gear backing ring - standard size?
I've just quickly measured about 10 and they are all 0.158" (give or take a thou) on the thinner part.
It would seem strange that they've all worn consistently. So if the MS one really is 0.164" as they state then it sounds a bit more than 2 thou oversize and could make up a good bit of your 12 needed!
It would seem strange that they've all worn consistently. So if the MS one really is 0.164" as they state then it sounds a bit more than 2 thou oversize and could make up a good bit of your 12 needed!