Mk1 65 s 1275
-
- 1275 Cooper S
- Posts: 2606
- Joined: Wed Oct 19, 2011 5:07 pm
- Location: Southern England
- Been thanked: 4 times
Re: Mk1 65 s 1275
You see those "Tudor" stickers/bottles on lots of restored Minis but I don't think they were ever fitted originally.
None of my own Minis ever had one and I still have a spare new bottle in an original BMC box which has no makers label on it
I think the Tudor bottles were an MG thing perhaps?
I do agree though, the car looks fantastic!!
None of my own Minis ever had one and I still have a spare new bottle in an original BMC box which has no makers label on it
I think the Tudor bottles were an MG thing perhaps?
I do agree though, the car looks fantastic!!
- Pete
- 1275 Cooper S
- Posts: 11080
- Joined: Fri Jun 25, 2010 10:47 pm
- Has thanked: 15 times
- Been thanked: 38 times
Re: Mk1 65 s 1275
I'll look for a better pic but it's something loads of restored cars miss, the hose on most if not all 65 cars is shorter, it stops at and is secured by a big C shaped bracket to the angled stiffener with a plastic grill on the end. I'm not sure on the exact dates of introduction nor deletion but was introduced no doubt because the long hose is too much of a squeeze in the engine bay and no doubt was discontinued due to unpleasant engine smells coming into the cabin. The one on this pic looks like it has been disconnected from it's mounting but you get the idea. I'll get a better photo off one of my own cars.Aginley wrote:
Have yo got a picture of how long the air tube is meant to be? I left it full length so I could chop it in situ. Definitely don’t want to remove it, it was a pig to fit..
You do not have the required permissions to view the files attached to this post.
- Nick W
- 1275 Cooper S
- Posts: 2892
- Joined: Sat Jan 17, 2015 8:59 pm
- Location: sheffield
- Has thanked: 1 time
- Been thanked: 6 times
Re: Mk1 65 s 1275
some images here
You do not have the required permissions to view the files attached to this post.
Up North in Sheffield
- Andrew1967
- 1275 Cooper S
- Posts: 7903
- Joined: Thu Jun 24, 2010 6:35 pm
- Location: Usually in my garage on the east coast of Norfolk, UK
- Been thanked: 1 time
Re: Mk1 65 s 1275
Good luck getting a repro hose past the regulator without having to squash it
Interesting that the regulator in Nick's picture is horizontal but should be vertical facing forwards. Might make the air hose pass by a bit easier.
Interesting that the regulator in Nick's picture is horizontal but should be vertical facing forwards. Might make the air hose pass by a bit easier.
-
- Basic 850
- Posts: 54
- Joined: Mon Oct 20, 2014 10:28 am
Re: Mk1 65 s 1275
Interesting that the regulator in Nick's picture is horizontal but should be vertical facing forwards. Might make the air hose pass by a bit easier.[/quote]
Not true !.....that picture is from my old 1275 s that had never been touched.......[ even Mr Parnell agrees with me that he could be mistaken in the bible ]
Not true !.....that picture is from my old 1275 s that had never been touched.......[ even Mr Parnell agrees with me that he could be mistaken in the bible ]
- Andrew1967
- 1275 Cooper S
- Posts: 7903
- Joined: Thu Jun 24, 2010 6:35 pm
- Location: Usually in my garage on the east coast of Norfolk, UK
- Been thanked: 1 time
Re: Mk1 65 s 1275
That's interesting and would make it much easier.
The holes in the inner wing of HOY would say that it was positioned vertically though
The holes in the inner wing of HOY would say that it was positioned vertically though
-
- Basic 850
- Posts: 54
- Joined: Mon Oct 20, 2014 10:28 am
- Nick W
- 1275 Cooper S
- Posts: 2892
- Joined: Sat Jan 17, 2015 8:59 pm
- Location: sheffield
- Has thanked: 1 time
- Been thanked: 6 times
Re: Mk1 65 s 1275
it may have been depending who was on regulator fitting duty on the day
Up North in Sheffield
- Simon776
- 1275 Cooper S
- Posts: 1181
- Joined: Thu Jun 24, 2010 6:08 pm
- Location: Shakspere's county
Re: Mk1 65 s 1275
Quite right, Mini's did not have that sticker and its the wrong washer bottle, that type was used on ADO16 and Sprite/Midget.You see those "Tudor" stickers/bottles on lots of restored Minis but I don't think they were ever fitted originally.
None of my own Minis ever had one and I still have a spare new bottle in an original BMC box which has no makers label on it
I think the Tudor bottles were an MG thing perhaps?
You decided not to keep the remote fuel gauge then It would have made an interesting talking point.
You do not have the required permissions to view the files attached to this post.
The power of accurate observation is commonly called cynicism by those who do not possess it.
-
- 998 Cooper
- Posts: 702
- Joined: Tue Jun 19, 2018 2:43 pm
- Location: Hertfordshire
- Has thanked: 19 times
- Been thanked: 4 times
Re: Mk1 65 s 1275
The question on the fresh air duct can I think be answered that certainly in year 65 my build was September and have noticed the same on an October 65 car that the fresh air hose only extended to this position it didn't go further to the front which appeared as such on later cars but not certain the change over date.Nick W wrote:some images here
I think the mesh grille is the giveaway.
Don't forget that with this installation one would be better informed when the carbs started to dribble fuel down to the manifold!
-
- 998 Cooper
- Posts: 702
- Joined: Tue Jun 19, 2018 2:43 pm
- Location: Hertfordshire
- Has thanked: 19 times
- Been thanked: 4 times
Re: Mk1 65 s 1275
Is the Lucas mirror from a Jag by any chance?Aginley wrote:New mirror fitted today.
Love it.
Re: Mk1 65 s 1275
Got it from eBay. Liked the look of it!richardACS wrote:Is the Lucas mirror from a Jag by any chance?Aginley wrote:New mirror fitted today.
Love it.
-
- 998 Cooper
- Posts: 702
- Joined: Tue Jun 19, 2018 2:43 pm
- Location: Hertfordshire
- Has thanked: 19 times
- Been thanked: 4 times
Re: Mk1 65 s 1275
Just about finished guys.
Few little jobs left. Going to attempt the front screen this afternoon!
Front grill to Finnish,
Few small wiring bits to do,
Couple of interior trim bits to do,
Then finally a rolling road session at southams!
Particularly impressed with the panel gaps and bodywork.
Few little jobs left. Going to attempt the front screen this afternoon!
Front grill to Finnish,
Few small wiring bits to do,
Couple of interior trim bits to do,
Then finally a rolling road session at southams!
Particularly impressed with the panel gaps and bodywork.
You do not have the required permissions to view the files attached to this post.
-
- 998 Cooper
- Posts: 272
- Joined: Mon Oct 28, 2019 3:18 pm
- Location: Zelzate - Belgium
- Contact:
Re: Mk1 65 s 1275
what a lovely car !! Wonderful, great work !!
Congratulations
Congratulations
MK1 Austin Cooper 998cc 1967 Smoke Grey
http://mk1-forum.net/viewtopic.php?f=6&t=26813
http://mk1-forum.net/viewtopic.php?f=6&t=26813
- AndyB72
- 1275 Cooper S
- Posts: 1381
- Joined: Thu Jun 24, 2010 12:44 pm
- Location: Wakefield, West Yorks
-
- Site Admin
- Posts: 19842
- Joined: Thu Jun 24, 2010 11:30 am
- Location: Away with the Faries
- Has thanked: 2 times
- Been thanked: 5 times
Re: Mk1 65 s 1275
That looks great Al.
Are you going to bring it down to the shed one night, once the weather improves?
M
Are you going to bring it down to the shed one night, once the weather improves?
M
Re: Mk1 65 s 1275
Wildo ,mk1 wrote:That looks great Al.
Are you going to bring it down to the shed one night, once the weather improves?
M