Not sure if I should call this spindle or shaft - the steel bits that turn including the advance weights and cam. Anyway it looks like the later 45D shaft is a possible drop in replacement for the 25D shaft, it goes into the 25D body and I can still use the 25D rotor arm.
Would like to know if anyone else has done this and if there is anything to watch out for?
Distributor : 45D spindle into 25D body?
-
carbon
- 998 Cooper
- Posts: 518
- Joined: Fri Jan 07, 2011 8:26 pm
- Location: Scotland
-
Tulka
- Basic 850
- Posts: 59
- Joined: Thu Jun 24, 2010 11:38 pm
Re: Distributor : 45D spindle into 25D body?
Possible to do. Many years ago I tried and if memory is correct it needed some extra shims. Think it gives less time to load condenser,so unsure if there is any benefit.
Tulka
edit;To clarify; I am talking about changing the complete rotating assembly.Not just the top part.
Tulka
edit;To clarify; I am talking about changing the complete rotating assembly.Not just the top part.