Pandora wrote:My my, the artist went all out on the names on those ones, didn't he!
I did think about Marigold and even a 'Downton' livery, given the engine mods, but I think it's just too obvious, and the original Marigold was an early van.
So lucky to get re-united with a past vehicle, i will be following your thread with interest.
On a separate note i was surprised to see the name Hadrian, i thought they had been swallowed up by Imperial, as mentioned at the top of the page in the link below.
Though it probably all links back to Imperial, they must still be using the name.
Looking at the rear load bed panel, am I right in thinking the construction detail cross section is as in this sketch? To properly replace the sides of the load bed (or indeed the whole panel) you'd remove the rear vallence and it is spot welded between it and the side panel lower edges
It's a bit of a patch work of past repairs, so I'm trying to work out what the original detail was like
Al
You do not have the required permissions to view the files attached to this post.
which are dead handy as I was unsure if the boxes above the front rear subframe mounts should be joined by a box section across the car, but gladly they are not.
I have got some photos where I'm replacing the lower quarters (and one quarter), the load bay edges, rear step and valance, in various states of unbuttoning and buttoning back up. I'll send them over if you are interested?
