photos
-
- 1275 Cooper S
- Posts: 2315
- Joined: Fri Jun 25, 2010 10:57 am
- Location: Colchester, Essex
- Has thanked: 2 times
- Been thanked: 1 time
Re: photos
Yes, great idea. I am trying to fathom out where the large Mk 1 heater air intake runs to at the moment and cannot find anything on line to refer back to. I can see it enters the bulkhead above tower subframe mount but can't figure is there should be a link pipe from this to the heater?
Rolesyboy
-
- Site Admin
- Posts: 19843
- Joined: Thu Jun 24, 2010 11:30 am
- Location: Away with the Faries
- Has thanked: 2 times
- Been thanked: 5 times
Re: photos
The course is pretty self evident, it goes through the hole in the bulkhead, through the hole in the parcel shelf and makes a B line towards the heater inlet across the top of the pedals. It is held in place by a very large steel jubilee TYPE clip.
For the route under the bonnet check out the press release pictures on the main MK1 site.
For the route under the bonnet check out the press release pictures on the main MK1 site.