Page 2 of 2

Re: 1mm i/d C clip/circlip

Posted: Tue Oct 12, 2021 8:52 pm
by Peter Laidler
The trouble with it is that the saw shakes like a kango hammer. Just machined a 2mm axle with 4BA treaded ends - hopefully! BUT your idea is a fxxxxxg good one because a coil of that spring steel curtain wire stuff that your mum used to hang the net curtains on would probably have done the job too.

This forum is a reat place for off-the-wall ideas

Re: 1mm i/d C clip/circlip

Posted: Tue Oct 12, 2021 9:01 pm
by Ronnie
I will send you some 0.8mm stainless lock wire & 1mm Inconel 600 free gratis if you want, let me know :?: :shock: