Page 1 of 1

D-Type pistons

Posted: Wed Nov 23, 2022 8:29 pm
by Rolandino
I just saw on the forum that someone wanted a set of D-type Cooper pistons, and I knew I had a set.
Fished it out and bugger me down!,3 pistons are at +020 the 4th is +030...had them since the 70's bought the set from a German.
Never trust them!
They are Kolben pistons and a full set of rings to go with them. I also have (somewhere) 8 neoprene buttons to replace the circlips.
The set for £150 ONO

If someone really wanted these they could spin the 030 down and regroove the ring slots...not a hard job on a lathe. then just re-gap the rings

ISXDB21.tmp.jpg
20221103_144101.jpg
20221103_144045.jpg
20221103_143938.jpg

Re: D-Type pistons

Posted: Wed Nov 23, 2022 8:31 pm
by almondgreen
Would be interested, but am a bad german

Re: D-Type pistons

Posted: Wed Nov 23, 2022 8:35 pm
by Rolandino
So am I ! I was kidding, I always thought I had 4 pistons at +020...

Re: D-Type pistons

Posted: Fri Nov 25, 2022 4:08 pm
by Andrew1967
Got a set of those Kolben Schmidt +20 D tops in my 998 Cooper.

Supplied by Minispares back in the early 90’s